Elfab’s
capsule insert Bursting Disc Holders have been designed and
manufactured specifically to ensure the correct performance
of Elfab’s bursting disc range when fitted between flanges.
Where applicable our holders are pre-configured to accept
the ATEX-approved Integral Flo-Tel™ burst detection switch.
Corrosion resistance (stainless steel as standard,
hastelloy for Opti-Gard™)
Superior leak tightness assured by N6 (Ra 0.8 microns)
clamp face surface finish and spiral gasket face
Produced to suit all internationally recognised flange
standards
Assured alignment via location between flange bolts
Also Available:
Wide range of alternative materials
System Loc
Special flange specifications
Multiple disc holders
Tappings (excess flow valve)
Dome protection (where not standard)
Special coatings and cladding
To ensure
the correct performance of a bursting disc, it must
be used in its correct holder, as specified by the bursting
disc manufacturer.
(Other combinations of holders and bursting discs should
not be used, or the holders modified).
Pressure Intelligence
The data shown on these sheets represents
the standard offering from Elfab. Depending upon the requirements of your
application, Elfab maybe able to provide a solution based on this product
but outside the standard operating parameters. In addition, Elfab produces
an extensive range of alternative products which maybe more suitable for
your requirements.
As a result of extensive testing, Elfab can advise on these choices, or
on other technical matters, such as discharge requirements, temperature
testing, material selection and corrosion resistance, customised designs
and burst detection.
To discuss your specific product or service requirements please
contact your Elfab representative.
