Products > Holders & Accessories > Bursting Disc Holders    Print this product datasheet
 
 
Elfab’s capsule insert Bursting Disc Holders have been designed and manufactured specifically to ensure the correct performance of Elfab’s bursting disc range when fitted between flanges.

Where applicable our holders are pre-configured to accept the ATEX-approved Integral Flo-Tel™ burst detection switch.
 

  • Corrosion resistance (stainless steel as standard, hastelloy for Opti-Gard™)
  • Superior leak tightness assured by N6 (Ra 0.8 microns) clamp face surface finish and spiral gasket face
  • Produced to suit all internationally recognised flange standards
  • Assured alignment via location between flange bolts
 

Also Available:
  • Wide range of alternative materials
  • System Loc
  • Special flange specifications
  • Multiple disc holders
  • Tappings (excess flow valve)
  • Dome protection (where not standard)
  • Special coatings and cladding

To ensure the correct performance of a bursting disc, it must be used in its correct holder, as specified by the bursting disc manufacturer.

(Other combinations of holders and bursting discs should not be used, or the holders modified).


Pressure Intelligence

 The data shown on these sheets represents the standard offering from Elfab. Depending upon the requirements of your application, Elfab maybe able to provide a solution based on this product but outside the standard operating parameters. In addition, Elfab produces an extensive range of alternative products which maybe more suitable for your requirements.

As a result of extensive testing, Elfab can advise on these choices, or on other technical matters, such as discharge requirements, temperature testing, material selection and corrosion resistance, customised designs and burst detection.

To discuss your specific product or service requirements please contact your Elfab representative.

© 2004 Elfab Ltd.

 
Click here to email our sales department. Click for more contact details.